This is an old revision of the document!

  1. Connect Ezurio Bluetooth to computer.
  2. Install NOAHlink drivers.
  3. Connect to NOAHlink using third-party drivers.
  4. Turn on NOAHlink.
  5. Control Panel > Bluetooth Devices > Add Wireless Device.
  6. Properties > Services > Serial Port SPP (Check it)
  7. Start > Programs > NOAHlink > NOAHlink Properties > Search.
  8. Connect to NOAHlink.
  1. Open “Bluetooth Devices”.
  2. Right-click the NOAHlink and select properties.
  3. Check the “Serial over Bluetooth” box.
  4. Run NOAHlink properties.
  5. Click the search button.
  6. Select the NoahLink in the top half of the window.
  7. Click the connect button.

If the serial cannot be enabled over bluetooth service in "Bluetooth Devices"

  1. Run services.msc
  2. Find and select the Bluetooth Support Service, right click and select Properties.
  3. Click the Stop button.
  4. Select the Log On tab, and select the radio button next to Local System account, then click Apply.
  5. Go back to the General tab and click the Start button.
  6. Click OK to close the Properties dialog.
ezfit/noahlink_installation_and_troubleshooting.1286457073.txt.gz · Last modified: 2010/10/07 09:11 by smayr
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International


  • Show pagesource
  • Old revisions
  • Backlinks
  • Recent Changes
  • Media Manager
  • Sitemap