This is an old revision of the document!
Software Development Meeting 2011-Jan-17
Software Review
- Complete top menus.
- Instruments:
- Remove Read button. — Siegwart Mayr 2011/01/17 16:04
- Add Simulation button. — Siegwart Mayr 2011/01/17 16:04
- Remove Auto Environment = 0, and any other field like that (such as Environment, Adapt Dir, NR Bands, Datalogger, Tinnitus). — Siegwart Mayr 2011/01/17 16:04
- Fitting:
- Add simulation data for selected instrument.
- Quick Adjustments:
- Add content to each panel (even if it is just a placeholder).
- Change “Wind Noise” to “Soft Touch”. — Siegwart Mayr 2011/01/17 16:08
- Connect:
- For first fitting, go to Initial Fit Settings / Initial Fit.
- For second fitting, go to Quick Adjustments.
- Fine Adjustments:
- Add binaural thumb for Gain/EQs.
- Disable EQs that are not supported. — Siegwart Mayr 2011/01/19 10:44
- Disable Freq Cut-off, Expansion, In Situ Verification, Datalog buttons, for instruments not supporting them.
- Rename “Other” to “Patient Controls”. — Siegwart Mayr 2011/01/17 16:08
- Patient Controls
- Set to read-only: Style, +Power Style, Serial Number. — Siegwart Mayr 2011/01/19 10:44
- Use On/Off (None/Push) for Memory Access. Do not display Toggle if not supported.
- Calibration:
- Reset instrument to Factory (default params, clear stored audiogram, reset serial number, etc.).
- Tools:
- Redesign to make it more modern.
Completed Actions
Conclusion
- Next meeting: Jan 31, 2011, 2pm