Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
ezfit:dev:software_meeting_2011-01-17 [2011/01/17 15:41] smayr [Software Review] |
ezfit:dev:software_meeting_2011-01-17 [2011/05/10 12:24] (current) smayr |
||
---|---|---|---|
Line 1: | Line 1: | ||
== Software Development Meeting 2011-Jan-17 == | == Software Development Meeting 2011-Jan-17 == | ||
- | Notes relevant to [[ezfit:5.0 Milestones|ezFIT 5.0 Milestones]]. | + | [[ezfit: |
Attendees: | Attendees: | ||
Line 14: | Line 14: | ||
* Complete top menus. | * Complete top menus. | ||
* Instruments: | * Instruments: | ||
- | * Remove Read button. | + | * Remove Read button. |
- | * Add Simulation button. | + | * Add Simulation button. |
- | * Remove Auto Environment = 0, and any other field like that. | + | * Remove Auto Environment = 0, and any other field like that (such as Environment, |
* Fitting: | * Fitting: | ||
- | * Add simulation data for selected instrument. | + | * Add simulation data for selected instrument. |
- | * Quck Adjustments: | + | * Quick Adjustments: |
- | * Add content to each panel (even if it is just a placeholder). | + | * Add content to each panel (even if it is just a placeholder). |
- | * Change "Wind Noise" to "Soft Touch" | + | * Change "Wind Noise" to "Soft Touch" |
* Connect: | * Connect: | ||
* For first fitting, go to Initial Fit Settings / Initial Fit. | * For first fitting, go to Initial Fit Settings / Initial Fit. | ||
Line 27: | Line 27: | ||
* Fine Adjustments: | * Fine Adjustments: | ||
* Add binaural thumb for Gain/EQs. | * Add binaural thumb for Gain/EQs. | ||
- | * Disable EQs that are not supported. | + | * Disable EQs that are not supported. |
- | * Disable Freq Cut-off, Expansion, In Situ Verifucation, Datalog buttons, for instruments not supporting them. | + | * Disable Freq Cut-off, Expansion, In Situ Verification, Datalog buttons, for instruments not supporting them. |
- | * Rename " | + | * Rename " |
* Patient Controls | * Patient Controls | ||
- | * Set to read-only: Style, +Power Style, Serial Number. | + | * Set to read-only: Style, +Power Style, Serial Number. |
- | * Use On/Off (None/Push) for Memory Access. Do not display Toggle if not supported. | + | * Use On/Off (None/Push) for Memory Access. Do not display Toggle if not supported. |
* Calibration: | * Calibration: | ||
* Reset instrument to Factory (default params, clear stored audiogram, reset serial number, etc.). | * Reset instrument to Factory (default params, clear stored audiogram, reset serial number, etc.). | ||
Line 43: | Line 43: | ||
== Conclusion == | == Conclusion == | ||
- | * Next meeting: Jan 31, 2011, 2pm | + | * Next meeting: |