Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
ezfit:dev:software_meeting_2010-06-21 [2010/06/23 11:49] smayr |
ezfit:dev:software_meeting_2010-06-21 [2011/05/10 12:21] (current) smayr [Software Development Meeting 2010-Jun-21] |
||
---|---|---|---|
Line 1: | Line 1: | ||
== Software Development Meeting 2010-Jun-21 == | == Software Development Meeting 2010-Jun-21 == | ||
- | Notes relevant to [[ezfit:5.0 Milestones|ezFIT 5.0 Milestones]]. | + | [[ezfit: |
Attendees: | Attendees: | ||
Line 13: | Line 13: | ||
== Software Review == | == Software Review == | ||
* Fitting | * Fitting | ||
- | * Graphing | + | * Graphing |
- | * ComponentOne Chart for WPF can paint regions (for displaying fitting ranges), do spline curves (for targets and response curves), etc. | + | * Demonstrated that ComponentOne Chart for WPF can paint regions (for displaying fitting ranges), do spline curves (for targets and response curves), etc. |
- | * General | + | * Arrived to general |
- | * Super-controls: | + | * Need to develop |
* Occlusion management. | * Occlusion management. | ||
* Overall gain. | * Overall gain. | ||
* Feeback management tool. | * Feeback management tool. | ||
* Adaptation manager (Acclimatization). | * Adaptation manager (Acclimatization). | ||
- | |||
== Suggested Actions == | == Suggested Actions == | ||
Line 42: | Line 41: | ||
For Barbara: | For Barbara: | ||
* Send Glenn audiogram that was trouble fitting from Bekah (Audigence). | * Send Glenn audiogram that was trouble fitting from Bekah (Audigence). | ||
+ | * Left: 20, 40, 42, 45, 42, 40, 60, 65, 68, 70 | ||
+ | * Right: 20, 30, 35, 40, 45, 50, 75, 75, 72, 70 | ||
+ | * Details: Issue with autofit not matching targets with FLX in a closed dome. From Steve' | ||
+ | It appears the matching (aka auto adjusting) algorithm works OK | ||
+ | for Intuition CICs, Mini Canals, FLX Open, and Sparo Open cases. | ||
+ | All others need help | ||
+ | |||
+ | The problem is relatively mild for Intuition Canals and Half shell configurations. | ||
+ | |||
+ | It gets real bad for I12 FSS and Super 60 cases, and of course FLX OTE (closed), | ||
+ | Earhook, as well as Sparo 12 Earhook, OTE closed | ||
+ | |||
+ | In all cases the greatest errors are in the low frequency region. | ||
+ | |||
+ | In addition to the basic matching requirement (which effects these products in general - | ||
+ | especially if someone is counting on the autofit) there is also an additional problem | ||
+ | when used with Claraijust. Presently the EQs are not centered in their range after the | ||
+ | matching algorithm has done its job. This can cause a problem as the Bump, Tilt and Gain | ||
+ | process won't have any adjustment room to do the optimization. | ||
+ | |||
+ | I also noticed that there is a receiver model error for the Sparo 12. When the OTE | ||
+ | configuration is used with a closed dome the receiver model needs to reflect the | ||
+ | increased Low Frequency content, at present it doesn' | ||
+ | thin tube Open model in place.</ | ||
For Glenn/ | For Glenn/ |